Pontoon Boat Seat Installation Instructions

PONTOON FURNITURE ASSEMBLY INSTRUCTIONS
Hardware Package: 1” Base screws, 4” threaded posts, fender washers, lock washers and wing nuts.
Tools Required: Matching pattern Phillips head hand or power screwdriver. Pliers.
NOTE: USE PLIERS TO REMOVE PLASTIC CORNER GUARDS INCLUDING ANY PROTRUDING STAPLES
All 27”, 36”, 45”, 50” Straight Benches & all 45” Corner Couches
Assembling Seat Bottom Cushion to Plastic Base
1. Remove the hinge from the seat cushion bottom by removing the screws.
Take note of the hinge placement for correct re-placement of hinge on
the base and bottom.
2. Place the hinge onto the seat base and insert the 1” base screws in the
3 pre-drilled holes in the seat base. Screw down but do not tighten yet.
3. Turn the seat base so that the front of the base is facing down.
4. Place the seat bottom next to the base to re-attach the 3 screws removed
from the hinge in step one. Start screws by hand only. Once started,
screw down but again do not tighten.
5. First tighten the 3 base hinge screws into the base. Second, tighten
the screws in the seat bottom cushion.
Important to tighten in this order!
All 27”, 36”, 45”, 50” Straight Benches,
All 25” - 32” Seats & All 45” Corner Couches

Back